Thermon RGS-SFK Instrukcja Użytkownika Pobierz pdf (Strona 2)

RGS

TM

-SFK Power Connection and End Termination Kit

Tools Required for Installation

Crimper/cutter, flat-blade screwdriver,

and utility knife

Kit Contents

(1) Splice/Tee, (1) End Termination

Splice and Tee Connection

Step 1: Allow 12" (30 cm) of extra length

for each heating cable at the connection

point.

Step 2: Cut overjackets back a distance

of 3" (70 mm).

Step 3: Separate braids and twist into pig-

tails. Carefully cut primary jackets back

2" (50 mm).

Step 4: Skive outer matrix material from

conductors with utility knife.

Step 5: Peel exposed wires back from

center matrix and cut center matrix away,

leaving bare conductors.

Step 6: wrap black mastic around each

cable beginning at a distance fo 1"

(25 mm) back from the pigtail (overjacket).

Step 7: Squeeze

RTV into the

silicone rubber

boots and slide

over cable ends.

Step 8: Stack the two (or three cables in

the case of a tee) together and tighten

down with two standard tie wraps at

8" (20 cm) and 10" (28 cm) respectively

from the exposed bus wire end.

Step 9: Twist all the pigtails together. Slide

the large un-insulated lug over the braid

ends in close proximity to the cables and

then crimp. Trim off any extra braid. Bend

pigtail back so that the crimp lug lies down.

1 2 3 4

Komentarze do niniejszej Instrukcji

Brak uwag