Thermon PCS-COM Instrukcja Użytkownika

For In-Line Splice Connection, T-Splice Connection,or End Termination Applications PCS-COMIn-line and T-Splice KitINSTALLATION PROCEDURESfor FLX, HSXP

51Kit Contents . . .The following installation procedures are suggested guidelines for the installation of Thermon’s PCS-COM connection systems. They

21.2. Slide expediter toward pipe and secure using two (2) circumferential bands of 19mm (3/4”) wide tape.1.3. Place UL® label provided as sho

31.8. Cutandremoveprimaryinsulationjacket. 1.9. Skive outside of black matrix.1.10. Cut v-notch in matrix and pull bus wires from matrix. Cu

43.3. Feed cable and ground through expediter base as shown. Feed cable and ground lead through grommet (above the crimp).3.2. Trim braid to a

53.9. Apply a liberal amount of RTV sealant to cable.3.10. Slide boot onto the end of the cable.4.1. Slide the metallic braid back from the end

65. Complete system wiring. Connect bus wires using wire nuts. Connect braid wires using wire nut. See wiring details for splice connections.6. In

Form No. 50401-1008THERMON . . . The Heat Tracing Specialists®100ThermonDr.• PO Box 609 • San Marcos, TX 78667-0609Phone: 512-396-5801 • Facs